Power On/Off - BlueAnt supertooth3 Manual Del Usuario

C. Charging
1. Connect the charger's plug into the Charger Port (9)
of the SUPERTOOTH 3. Connect the charger to an
external power source.
Charge Indicator (4) Status:
Steady red: Low Battery
Steady orange: Charging
Steady green: Full Charge Speech: Fully Charged
2. When the Supertooth 3 is fully charged,
disconnect the charger.
4
Speech: Low Battery
Speech: Charging
D. Power On/Off
Power On: Press MFB (1) for 1 second. The Bluetooth
Indicator (3) will turn blinking blue and a voice will say,
"SUPERTOOTH 3 ready. Connected to phone (or if
phone not available: No phone detected)."
Note: The fi rst time the SUPERTOOTH 3 is switched on, the
language selection is automatically activated. In this case,
proceed to Section E (Procedure 2).
Power Off: Press and hold MFB (1) for 5 seconds until
a voice announces, "SUPERTOOTH 3 powering
down." The Bluetooth Indicator (3) will turn a steady
red for 4 seconds, the device will then switch off.