CASUALPLAY Baby 0+ Safe tech Manual De Instrucciones página 25

Disconnecting the
TECH
• Pull the release device found on the backrest of the
indicators on the front part of the base fix Baby 0
that the seat has been correctly disconnected.
• Pull the seat upwards (fig.19).
Installing the Baby 0
This exclusive fastening system means that the Baby 0
the following pushchairs: Vintage, Vintage2, Vintage3, Jazz, S4, Downtown, S4-reverse,
S-twinner, Avant, Kudu and Kudu Four. For all of them the procedure to fit the Baby 0+
SAFE TECH is the following:
• Put the parking brake on.
• Place the Baby 0
+
• Line the Unisystem fasteners on the
• Press downwards until it clicks fastened and a green signal appears in each of the
windows on the sides of the fasteners (fig.21).
Baby 0
• To take the
fasteners (red signal in the window) and pull upwards to release it from the pushchair
chassis (fig.22).
Using the Baby 0
Baby 0
• Place the
+
• Move the handle to the rocker position (consult the section about how to adjust the
carrying handle). Make sure that it clicks into position (fig.5) (C).
Baby 0
• The
+ SAFE TECH
• The baby should wear the harness fastened and should never be left alone.
WARNING: Never leave the child unsupervised.
Using the Baby 0
• Place the Baby 0
+
• Move the handle to the stability position (consult the section about how to adjust the
carrying handle). Make sure that it clicks into position (fig.5) (A).
• The Baby 0
+ SAFE TECH
Baby 0
+
SAFE TECH
on the pushchair
+
SAFE TECH
on the pushchair, facing backwards.
SAFE TECH
Baby 0
off, press and then release the red button on both
+ SAFE TECH
+
SAFE TECH
on the floor on a flat surface.
SAFE TECH
will move as your baby moves.
+
SAFE TECH
on the floor on a flat surface.
SAFE TECH
can now be used as a seat for the baby.
from the BASE FIX
Baby 0
+ SAFE TECH
will turn red, indicating
SAFE TECH
+
+ SAFE TECH
up with the slots (fig.20).
SAFE TECH
+
as a rocker
as a seat
Baby 0
+
SAFE
(fig.18). The
can be used on
23 23