Cutting disc
a) Verify that the disc nut is not loose, tighten it if necessary.
b) Check that the disc does not have cracks, notches, or that it
is not worn out. Replace it if necessary.
Case
a) Verify that the case is fixed correctly. Tighten the screws if necessary.
b) Verify that the case is not damaged. Replace it if necessary.
Spark plug
a) Lift the pipe.
b) Clean the fine coal off the
electrode.
c) Measure the free
space.(0,6~0,7mm)
Fuel filter revision and cleaning the fuel tank
a) Take the cap off.
b) Empty the fuel.
c) Take the fuel filter out and clean it carefully.
d) Clean the dirt from the fuel tank rinsing its interior with fuel.
Refrigeration system
Verify the case and that there is not dirt between the engine fins.
Fuel pipe
Verify that the fuel pipe and the overflow pipe are not deteriorated.
Storage
a) Empty the fuel from the deposit.
b) Start the engine and let it run until it stops.
c) Keep the brushcutter and its equipment in a clean zone.
d) Keep the blade from cut with its protector.
37