How To Assemble Your Light Kit Or Cap - Fanimation PYRAMID LP8406 Manual De Instrucciones

How to Assemble Your Ceiling Fan Blades (continued)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
2. Secure the blade holders to the motor support
on the bottom of the motor support. (Figure 2)
Periodically check blade holder hardware
NOTE:
and resecure if necessary.

How to Assemble Your Light Kit or Cap

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light plate assemly to the support
bracket using the two key slots in the light plate
assmbly. Replace the previously removed screw
and securely tighten all three screws. (Figure 2)
Motor Assembly
1/4
Motor
Assembly
Motor
Assembly
12
(3 per assembly)
Figure 2
HARDWARE USED:
x 9
Figure 1
Figure 2
Blade Holder
Light Plate
Assembly