Shindaiwa 65001 Manual De Propietario Y Operador página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Disassembling The Pole Sections
1. Place the Multipurpose Tool Carrier and the Tool Assembly on a clean, flat sur-
face, loosen the coupler screw knob (D). The spring-loaded coupler protector
(G) should pop up.
2. Press down on the latch (F) with your finger or thumb. This releases the cou-
pler latch.
3. Pull the tool assembly (B) out of the coupler (E).
Cutting Attachment Shield
Install the Cutting Attachment Shield.
1. Insert the cutting attachment shield (A)
between the outer tube and the cutting
attachment mounting plate (B).
NOTE:
It may be necessary to loosen the retaining
nut (C) and clamp screw (D)to adjust cut-
ting attachment shield mounting plate.
2. Fit the two shims (E) and the bracket (F)
over the outer tube and loosely install
the four socket-head screws (G).
CAUTION!
Make sure the clamp screw and retain-
ing nut is securely tightened before
tightening the four socket head screws.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
WARNING!
NEVER operate the trimmer without the
cutting attachment shield installed and
tightly secured!
6
G
F
E
D
1025
C
E
D
E
B
G
M23005
M23006
A

Publicidad

Tabla de contenido
loading

Tabla de contenido