Avery Dennison Monarch 9906 Referencia Rápida página 3

6. Push down on the supply lever to unlock the supply guide.
7. Lay the label strip across the supply guide so that a few
inches extend past the front of the printer.
8. Tuck the supply under the nibs and in between the die cut
sensor.
9. Adjust the supply guide so that it barely touches the supply.
Push up on the supply lever to lock the supply guides into
place.
Die Cut
Sensor
10. Hold the printhead assembly by the printhead tab while
pushing the printhead release.
Nibs
Supply Lever
Printhead Release
Printhead Tab
EN-3