Craftsman 247.886640 Manual Del Propietário página 7

1. Locate the shave plate in Figure 6. The space
between this shave plate and ground can be
adjusted.
2. For close snow removal on smooth surface, raise
skid shoes higher. See Figure 5.
3. Place skid shoes in middle or lower position when
the area to be cleared is uneven. See Figure 5.
4. Adjust skid shoes by loosening the four hex nuts
and carriage bolts as shown in Figure 5. Move skid
shoes to desired position.
5. Make certain the entire bottom surface of skid shoe
is against the ground to avoid uneven wear on the
skid shoes. Retighten nuts and bolts securely.
Tire Pressure
The tires are overinflated for shipping purposes.
1. Check tire pressure. Maintain pressure between 15
to 20 psi. Refer to tire sidewalls for recommended
tire pressure.
NOTE: If the tire pressure is not equal in beth tires, the
unit may pull to ene side or the ether.
_ WARNING:
Maximum tire under
pressure
any circumstance is 20 psi. Equal tire pressure
should be maintained at all times. Excessive
pressure (over 20 psi) when seating beads
may cause tire!rim assembly to burst with force
sufficient to cause serious injury.