N-Com B601 S Serie Manual Del Usuario página 10

EN
 Replace the polystyrene cheek pad (left side), positioning the cable in the groove that you see in the cheek
pad.
Note: Make sure the cheek pad is properly positioned in its housing, pushing in the lined corner underneath
the ribbing on the shell.
Fig. 14
Fig. 17
Fig. 18
 Before you place the speaker in its housing, apply the Velcro pad to the polystyrene cheek pad (right side).
 Position the loudspeaker in its housing obtained in the polystyrene cheek pad (right side).
 Replace the polystyrene cheek pad (right side), positioning the cable in the groove you see in the cheek pad.
ONLY FOR FULL-FACE HELMETS: Insert the chin guard (microphone side), gently placing the microphone in its
housing. Then press down on the red tab until the chin guard is locked in place on the helmet.
 Position the comfort padding in its housing (see specific instructions provided in the helmet user manual),
hooking the neck roll.
 Position both the comfort cheek pads in their housing (see specific instructions provided in the helmet user
manual) making sure that all the press-studs click.
Note: Carefully check the proper final positioning of the cheek pad, pulling the chinstrap toward the inside of
the helmet and testing the press-studs.
Caution: Make sure that there are no cables sticking out of the helmet and that the loudspeakers are in their
housing.
Caution: Always verify the proper length of the chinstrap and adjust it as necessary, once again referring to the
specific helmet instructions.
10
Fig. 15
ONLY FOR JET HELMETS OR FLIP-UP HELMETS:
 Secure the battery-holder support to the right side of the helmet,
lining up the holes with the pins on the shell (Fig. 17).
ONLY FOR FULL FACE HELMETS
Position the battery in the right polystyrene cheek pad housing

(Fig. 18).
Fig. 16