Removing The System; Basic Functions; Volume Adjustment; Multi-Language Voice Messages - N-Com B601 S Serie Manual Del Usuario

 Position the e-box in the relevant housing. First insert the front part, then press down on the e-box until
both hooks fully click.
Warning: Do not leave the helmet exposed to atmospheric agents without the e-box or the protection plate
provided with the helmet.
3.3

Removing the system

Fig. 19
 Remove the protection plate, then, looking at the helmet from the outside, release the connector by acting
on the fastening clasp as illustrated in the figure.
 After releasing the connector from the shell, also remove the right part by releasing the battery holder.
 Now remove the entire system from the helmet.
4

BASIC FUNCTIONS

Note: Before using the N-Com device for the first time, recharge the battery completely for at least 10 hours.
To obtain best performances from the battery, it is recommended to completely recharge the battery the first
few times. Afterwards, you can recharge the battery for shorter periods. Whenever possible, it is best to
recharge the battery completely.
System ON
System OFF
4.1

Volume adjustment

You can easily adjust the volume by tapping the "" or "" key. You will hear a beep when the volume
reaches the maximum or minimum level.
The volume is independent for each sound source. Once it is set for a specific source (phone call, radio, Mp3),
it will be remain in memory even after the system is switched off.
However, if you adjust the volume during stand-by mode, it will affect volume levels of every audio source.
4.2

Multi-language voice messages

The N-Com system features voice messages that provide information on the system and on the active
functions.
The language set by default is English. The language of the voice messages may be changed through the
specific firmware installable with the N-Com EASYSET program. Please refer to the online HELP for instructions
on how to change the language settings.
Available languages: Italian, English, French, German, Spanish, Dutch.
4.3

N-Com EASYSET

"N-Com EASYSET" is the application that can be used to manage and configure the B601 system.
The programme can be downloaded from the Internet site www.n-com.it, in the "Download"
section. The functions that can also be managed from the N-Com EASYSET are listed here below
with the specific icon.
 To remove the system from the helmet, remove the earphone
and the comfort cheek pads as shown in the assembly
operations. Then remove the polystyrene cheek pads.
 To remove the e-box, press the two sliding hooks at the same
time until the e-box comes out.
Press "ON" and keep it pressed for about 2 seconds, until the LEDs turn on and
you hear the voice announcement.
Press "ON" and keep it pressed for about 3 seconds, until the LEDs turn off and
you hear the voice announcement.
11