Installing The Microphone; Installing The System On The Helmet - N-Com B601 S Serie Manual Del Usuario

3.1

Installing the microphone

JET HELMETS OR FLIP-UP HELMETS
 Prepare the microphone by inserting the microphone clamp, being careful to position it properly (Fig. 6).
 Position the microphone in its support as shown in figure 7. Make sure that the side of the microphone with
the caption "n" is facing the inside of the helmet.
 Insert screw in the microphone clamp; use the key to screw in the microphone securing screw to the shell
frame (Fig. 8).
Fig. 6
FULL-FACE HELMETS
Take the polystyrene cheek pad (left-hand side) and position the microphone in its housing, as shown in Fig. 9.
Make sure that the side of the microphone with the caption "n" is facing the inside of the helmet.
Fig. 9
3.2

Installing the system on the helmet

 Position the system inside the helmet as shown in figure 11, next to the N-Com housing in the shell.
 Looking at the helmet from the outside, slide the rear positioning tab into groove A as shown in the figure.
 Press in the area marked PUSH from inside the helmet until the fastening clasp B clicks (Fig. 12).
 Pull out the connector's area from the helmet gasket: the gasket will have to be slightly deformed to
facilitate the insertion (Fig. 13).
Fig. 11
 Insert the microphone connector in the micro USB electronic plate (Fig. 14).
 Before you place the speaker in its housing, apply the Velcro pad to the polystyrene cheek pad (Fig. 15).
 Position the loudspeaker in the special housing obtained in the polystyrene cheek pad (Fig. 16).
Fig. 7
Fig. 10
Fig. 12
Fig. 8
Fig. 13
9