Installation - N-Com B601 S Serie Manual Del Usuario

EN
3

INSTALLATION

Important: Prior to installing the N-Com system, it is recommended to write down the identification code
affixed to the product (see chapter 16.5).
You can download the installation video from
 Remove the "N-Com" protection plate located on the helmet shell (Fig. 1) and open the helmet chin guard
(flip up helmets).
 Remove the right and left cheek pads from the helmet (see specific instructions provided in the user manual
of the helmet).
 Remove the back of the comfort padding by pulling on the neck roll until it separates from the shell.
 Temporarily put the padding on the outside of the helmet (Fig. 2).
 Remove the N-Com cover from the helmet border gasket. Push from the inside of the helmet to facilitate
the removal (Fig. 3).
Fig. 1
Fig. 4
Fig. 5
8
www.n-com.it N-Com / Download section.
Fig. 2
ONLY FOR FULL-FACE HELMETS:
 Remove the chin guard by pulling on the special red tab (Fig. 4).
 Remove the right and left polystyrene cheek pads by gently pulling
them out of the helmet. The helmet shell can be opened slightly to
facilitate the removal of the cheek pad.
Caution: In case the polystyrene cheek pad is damaged during this
operation, turn to your local dealer for its replacement.
Fig. 3