Amana G32026 Manual De Instrucciones página 6

Installation
3. Insert the screws in the sequence as
shown.
Upper
Handle
1
3
4. Ensure the door handle is snug to the
door panel.
To Remove:
Reverse installation procedure.
Freezer Handles
Partial-Width Handle
Materials Needed:
• Phillips screwdriver
To Install:
1. Install handle by fastening with
screws removed from edge of door.
• If reversing freezer door, remove
door plugs from top edge of door
and insert into screw holes.
To Remove:
1. Remove handle screws with Phillips
screwdriver and retain screws for
later use.
Front Mount Handle - Style 2
Materials Needed:
• Gloves to protect hands
Attach Extensions to Handle: (select models)
1. Align handle and
extension as shown.
2. Place extension in
handle opening.
3. Apply slight pressure
to both sides of the extension piece.
4. Slide extension until it stops on inside edge of
handle.
5
2
4
Lower
Handle
To Install:
1. The handles are to be oriented
as shown.
2. Align door handle clip with the
door studs.
3. Ensure the large hole in the
mounting clip is positioned
down on both ends of the
handle.
4. Rotate the handle so that the
handle is flat against the door.
5. Grasp the handle firmly and slide
down.
To Remove:
1. Grasp the lower part of the handle
firmly, slide up, lift and remove from
the surface.
Front Mount Freezer Handle
Materials Needed:
• Gloves to protect hands.
Notes:
• There is a slight curve to
this style of freezer
handle.
• For proper installation, be
sure handle is oriented as shown.
Door
Stud