Additional Information; Warranty Information - D-Link DCS-4603 Guia De Instalacion

Using the DCS-37-2 Mount (optional)
Place the DCS-37-2 mounting sticker in the desired location,
then use a 6 mm drill bit to drill the required holes 25 mm
deep and insert the wall anchors into the holes. If you plan to
pass cables through the wall, you will also need to drill a hole
for the cable channel.
Use the provided screws to mount the DCS-37-2 to the wall
using the inner mounting holes.
Remove the cover from the camera.
Pass the camera connectors through the back or side cable
channel on the DCS-37-2. Use the provided screws to mount
the camera to the DCS-37-2 using the set of mounting holes
marked A.
Remove the inner cover and adjust the angle and rotation
of the camera as desired, then put the inner cover back in
place.
Attach the camera cover.
If you are passing the camera cables through the wall, place
the rubber stopper into the bottom cable channel to seal it.

Additional Information

Additional help and product information is available online
at http://www.dlink.com.

Warranty Information

Please visit http://warranty.dlink.com/ for warranty
information for your region.
8
D-Link DCS-4603 Quick Installation Guide