D-Link DCS-4603 Guia De Instalacion página 9

Using the DCS-37-1 Mount (optional)
Place the DCS-37-1 mounting sticker in the
desired location, then use a 6 mm drill bit to drill
the required holes 25 mm deep and insert the wall
anchors into the holes. If you plan to pass cables
through the wall, you will also need to drill a hole for
the cable channel.
Use the provided screws to mount the DCS-37-1 to
the wall.
Remove the cover from the camera.
Pass the camera connectors through the back
or bottom cable channel on the DCS-37-1. Use
the provided screws to mount the camera to
the DCS-37-1 using the set of mounting holes
marked A.
Remove the inner cover and adjust the angle and
rotation of the camera as desired, then put the inner
cover back in place.
Attach the camera cover.
If you are passing the camera cables through the
wall, place the rubber stopper into the bottom cable
channel to seal it.
7
D-Link DCS-4603 Quick Installation Guide