Pairing-Procedure - Midland 445 BT Manual Del Usuario

Pairing-Procedure

If there is any paired Bluetooth Headset nearby (range up to some meters), it can be connected with the radio.
Before first connection, both units (radio and headset) must be paired toghether, because both must know that they „belong" to
each other. This is important, because you certainly do not wish that your neighbor can use your radio without your agreement!
How to perform the Pairing Process:
•
Do not release the button now- keep it further pressed. After some more seconds, the LED starts flashing red and
green rapidly. This shows, that Your radio is now ready for pairing, it is waiting for a Bluetooth headset in the range
•
Please study the user instructions for your headset. Although the procedure is similar
among many Bluetooth sets, we cannot describe all these procedures here. Please
study the chapter about pairing with a mobile phone, the procedure to pair it with
the 445 BT is the same! Nearly all headsets indicate the pairing process by rapid
flashing of the LED's (green-red or blue red, depending on the model)
•
Before pairing, start with switched off Bluetooth functions of both units. To make
sure that the BT function of the 445 BT is really switched off, switch the radio on and
press the Bluetooth button at least for 4 seconds, until the LED will flash 4 x red.
Now the Bluetooth function is off.
•
Now switch the Bluetooth function on again: Press the Bluetooth button and keep it
continuously pressed. After the first 4 seconds, You will see the BT function switch
on again ( 4 x green flashing). This shows that BT is now on.