Troubleshooting; Identificación De Fallas - Senco JoistPro 150XP Instrucciones De Operación

Ocultar thumbs Ver también para JoistPro 150XP:
Tabla de contenido

Publicidad

TrOUBLEShOOTiNg

ENgLiSh
WArNiNg
Repairs other than those
described here should be
performed only by trained,
qualified personnel. Contact
SENCO for information at
1-800-543-4596.
z l Read section titled "Safety
Warnings" before maintain-
ing tool.
SYMPTOM
z Air leak near top of tool /
Sluggish operation.
SOLUTION
z Verify air supply / tighten
screws or install Parts
Kit A.
SYMPTOM
z Air leak near bottom of tool/
Poor return.
SOLUTION
z Clean tool / tighten screws
or install Parts Kit B.
SYMPTOM
z Other problems.
SOLUTION
z Contact SENCO.
iDENTiFiCACióN DE FALLAS
ESpAñOL
ALErTA
Las reparaciones, fuera de
aquellas descritas aquí, deben
de ser llevadas a cabo solamente
por personal entrenado y
calificado. Póngase en contacto
con SENCO para información
1-800-543-4596.
z l Lea la sección titulada
"Avisos de Seguridad"
antes de darle
mantenimiento a la her-
ramienta.
SÍNTOMA
z El aire se escapa cerca de
la parte superior de la her-
ramienta / Operación lenta.
SOLUCIÓN
z Apriete los tornillos / Veri-
fique el suministro de aire o
instale el Juego de Partes
A (Parts Kit A).
SÍNTOMA
z El aire se fuga cerca de
la parte inferior de la her-
ramienta / Mal retorno.
SOLUCIÓN
z Apriete los tornillos / Limpié
la herramienta o instale el
Juego de Partes B (Parts
Kit B).
SÍNTOMA
z Otros problemas.
SOLUCIÓN
z Póngase en contacto con
SENCO.
DÉpANNAgE
FrANçAiS
AVErTiSSEMENT
Les réparations autres que
celles décrites ici doivent être
réalisées uniquement par du
personnel qualifié ayant reçu
la formation appropriée. Pour
toute information, prenez
contact avec SENCO par
téléphone en appelant Le
Distributeur agréé.
z l Lisez la section intitulée
"Consignes de Sécurité"
avant d'effectuer l'entretien
de l'outil.
SYMPTÔME
Fuite d'air près du sommet
de l'outil / fonctionnement lent.
SOLUTION
z Serrez les vis à fond /
vérifiez l'alimentation en air
ou remplacez les pièces
portant la lettre "A".
SYMPTÔME
z Fuite d'air près de la base
de l'outil / retour inadéquat.
SOLUTION
z Serrez les vis à fond / net-
toyez l'outil ou remplacez
les pièces portant la lettre
"B"
SYMPTÔME
z Autres problèmes.
SOLUTION
z Prenez contact avec
SENCO.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Joistpro 250xpJoistpro 150mxpJoistpro 250mxp

Tabla de contenido