Important; Pre-Installation Information; Supplies Required; Tools Required - Bradley OmniDeck 5000 Serie Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
Turn OFF electrical power to the electrical outlets, then unplug all electrical units prior to installation. Electrical
power MUST remain off until installation is complete.
Installer's hardware must be appropriate for wall construction. Wall anchors must have a minimum pull-out
rating of 1,000 pounds.
Read this entire installation manual to ensure proper installation. When finished wi th the installation, file this
manual with the owner or maintenance department. Compliance and conformity to local codes and ordinances
is the responsibility of the installer. Product warranties may be found under "Resources" on our website at
www.bradleycorp.com.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
For standard height mounting, do not exceed the recommended 33.5" distance from the fixture rim to the
finished floor.
Troubleshooting and internal maintenance must be performed by qualified service personnel.

Supplies Required

3/8" Fasteners & Wall Anchors for Wall Bracket
(minimum pull-out rating of 1000 lb)
#10 Fasteners & Wall Anchors for Soap Tank Brackets
(minimum pull-out rating of 100 lb)
#10 Fasteners & Wall Anchors for Access Panel Brackets
(minimum pull-out rating of 100 lb)
1/2" Hot/Cold or Tempered Stub-outs
1-1/2" NPT Drain Stub-outs
Dedicated 120V AC, 20A GFCI Outlets

Tools Required

• Drill
• Basin Wrench
• Tape Measure
• Phillips Screw Driver
• Flat Head Screw Driver
• Level
• 5/16" nut driver
• 5/16" socket (with or without extension)
• Construction adhesive suitable for solid surface, forming a strong permanent bond
Bradley • 215-1869 Rev. E: ECO 19-11-006

IMPORTANT

Item
WARNING
1 Bowl
2 Bowls
4
6
4
8
4
8
1
2
1
2
1
2
3 Bowls
4 Bowls
8
10
12
16
12
16
3
4
3
4
3
4
11/21/2019
LD-5010
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Omnideck ld-5010

Tabla de contenido