Guinaz M2710D Guia De Instalacion página 4

COLOCACIÓN DE LOS TARJETEROS.
1
Extract the name card unit
from the push-button
module of the street panel.
WHEN INSTALLING THE STREET PANEL FOR THE FIRST TIME, THE UPPER AND
LOWER COVERS MUST BE ASSEMBLED BEFORE CLOSING IT (SEE POINT
INSTALLATION OF STREET PANEL ). PRESS THE COVERS OVER THE FRAMES
UNTIL THEY CLIP IN.
THE UPPER AND LOWER COVERS CAN ONLY BE ATTACHED OR REMOVED WHEN
THE STREET PANEL OPEN. Once the street panel is closed, the anchoring strips of the
covers will be trapped in the panel itself in order to avoid vandalism.
IT IS NOT NECESSARY TO REMOVE THE UPPER AND LOWER COVERS IN ORDER
TO OPEN THE STREET PANEL. Follow the instructions in point INSTALLATION OF THE
STREET PANEL.
PLACEMENT OF NAME TAGS.
2
Separate
translucent glass part.
The street panel is sufficiently protected against
atmospheric conditions. However, it is
recommendable to install it in a place where agents
such as rain, humidity, etc. cannot affect it.
When the street panel is exposed to the elements it
is recommendable to install it with a visor frame. In
the case of surfaces that are not smooth, where the
street panel or visor frame are not perfectly sealed
with the joints that are incorporated, then some sort
of sealer should be applied throughout the entire
upper part of the street panel or visor frame to thus
avoid water from penetrating and damaging the
equipment.
3
Insert the card.
When choosing the location to install a
video door entry system it is important to
find a location where the source of light
(sun, street lamps, etc.) does not directly
affect the camera, to thus avoid the effect
of the back light on the image.
If the image is not clear and sharp due
to a lack of light for camera, then auxiliary
lighting should be placed as is duly
indicated in the figure. This auxiliary
lighting can be installed in such a way
that it only lights up the scene when a
monitor is working.
4
Insert in the push-button
module until it clips in.