Guinaz M2710D Guia De Instalacion página 5

INSTALACIÓN DE FUENTE DE ALIMENTACIÓN.
The power supply can be installed on a DIN slide or by means of sleeper-screws into the wall, always internally.
INSTALACIÓN MONITORES.
1
Assemble this wall base panel on the wall using four
sleeper-screws and connect it to the connection card.
3
Assembly of the monitor:
A) Assemble on the wall base.
B) Press down until it clips in.
Installing the monitor in places where calls can be heard all around the dwelling and far from heat sources (radiators, heaters, etc.)
or aggressive environments (kitchens, etc.) is recommended.
INSTALLATION OF MONITORS.
2
4
Disassembly of the monitor:
INSTALLATION OF POWER SUPPLY.
Configure the connection card of the wall base as indicated
in page 7, and connect the connector of the monitor.
A) Unclip with a screwdriver.
B) Move up and then outwards.