Access Codes; Setting The Parameters - HUEGLI TECH HT GC310 Manual De Instrucciones

A pair of numbers are displayed on the right in this line. The first indicates which entry in the menu is selected or which
page is displayed, the seconds indicates how many entries or pages can be displayed in the current menu/submenu.

Access codes

3.4.1.1
Access to the programming mode can be controlled by 4 different PASSWORD levels, which are listed in order of priority.
1.
2.
3.
4.
Warning: If the password is lost, you can reconfigure it using a higher level password. Contact our service
centre if the "MANUFACTURER" password is lost.
In the first page (000-Access Code) of the SYSTEM menu, you will be prompted for an access code if one or more
passwords have been assigned.
If a password is set to 0, it is not assigned and not required.
The USER can only display and change the User Password.
The INSTALLER can change the User Password and the Installer Password.
The MANUFACTURER can change all three passwords.
SICES can display and change some critical parameters for configuring the plant, for
parallel function.
Warning: The critical parameters must not be changed by the user.
The Password setting pages are displayed in the SYSTEM menu, if the user is authorised to change the settings.
When in programming mode and entering the Password, in the event the 'change password' page in not displayed, press
the EXIT/SHIFT
The set access code remains in the memory for about 10 minutes after programming has been completed. After that it
must be entered again to access the programming mode.

Setting the parameters

3.4.1.2
Enable the mode with the ACK/ENTER
Use the vertical scroll UP
to access. Select the variable or submenu with the UP
ACK/ENTER
The value of the variable is displayed in square brackets, for example: [400]
To change the variable, press ACK/ENTER
and DOWN
1a
cancel.
User's Manual HT GC310/HT GC350/HT GC500
12
SICES password
HT GC500
Manufacturer password
Installer password
User password
button to return to the previous menu and try to access the page again.
button.
and DOWN
Ref. 1a
when there are no submenus, displays the page of variables for the menu entry.
buttons to modify the value and press ACK/ENTER
Ref. 1a
buttons to select a menu and press ACK/ENTER
Ref. 1a
and DOWN
Ref. 1a
; the square brackets [ ] will blink. Use the vertical scroll UP
buttons. Pressing
Ref. 1a
to confirm or EXIT/SHIFT
Ref.
to