Special Settings; Selecting The Language; Fuel Pump (If Installed); Select Operation - HUEGLI TECH HT GC310 Manual De Instrucciones

4. Special settings

4.1 Selecting the language

Gen-set can display messages in various languages.
To select a different language use the UP
mode and, while the card is powered, press contemporarily the STOP
display shows the following message:
Special Function
Function [LANGUAGE]
Press the ACK/ENTER
password.
Press the ACK/ENTER
password value to 1. Press again the ACK/ENTER
When a proper password is entered, the language selection page will be displayed.
Press the ACK/ENTER
set the desired language; press ACK/ENTER
To exit the special mode, power down Gen-set, wait for a few seconds, then power it up again.
Note:in this phase do not press the STOP

5. Fuel pump (if installed)

Gen-set implements the full management of the fuel pump, to pump fuel from the storage tank to the tank on the
generator. The pump can be automatically or manually managed using the controls on the front panel.

5.1 Select operation

Pressing the UP
"STATUS INFORMATION S.xx" mode pressing the UP
Scroll through the pages using the LEFT
standard set-up procedure pressing the ACK/ENTER
the UP
Ref. 1a
button and press ACK/ENTER
button and use the UP
button and use the UP
and DOWN
Ref. 1b
and DOWN buttons to modify the command mode:
Ref. 1a
and DOWN
Ref. 1b
once more; you will be prompted to enter a
and DOWN
Ref. 1a
button to confirm.
and DOWN
Ref. 1a
to confirm.
and START buttons.
buttons to select the MAN, AUTO or TESTmode; select
Ref. 1b
and DOWN
Ref. 1a
and RIGHT buttons to page S.07. It is now possible to use the
button to start (square brackets blinking [xxxxxxx]), and
User's Manual HT GC310/HT GC350/HT GC500
buttons to access the OFF/RESET
Ref. 1b
and START
vertical scroll buttons to set a
Ref. 1a
vertical scroll buttons to
Ref. 1a
buttons.
Ref. 1a
buttons until the
17