Remington iLIGHT Pro Guía De Uso Y Cuidado página 22

Troubleshooting
PROBLEM POSSIBLE WHAT YOU SHOULD DO
CAUSE
A light flash The SKIN Check that both SKIN CONTACT SENSORS are
is not emit- CONTACT touching your skin. The Remington iLIGHT device
ted when SENSORS are won't work unless it's flat against your skin. See
I press the not in full steps 2b-2f in Figure 3 for this situation.
FLASH contact with
BUTTON. the skin.
You have not The Remington iLIGHT device requires 3 sec-
waited enough onds to recover between flashes. When the
time between device is ready to flash (and assuming the SKIN
flashes for the CONTACT SENSORS are flush against the skin),
Remington iLIGHT the device will emit three "BEEPS" to confirm
bulb to recover. that it is ready to flash. See steps 2b-2f in
Figure 3 for this situation.
The Make sure that the CARTRIDGE STATUS INDICATOR
REPLACEMENT
DISPLAY is either solid green or solid yellow. If it is
CARTRIDGE
flashing yellow, disconnect the Remington iLIGHT
needs to be
device and replace the REPLACEMENT CARTRIDGE.
replaced. You
Refer to "Replacing the REPLACEMENT CARTRIDGE"
should see the
Light Bulb flash-
in Figure 5.
ing YELLOW.
42
PROBLEM POSSIBLE WHAT YOU SHOULD DO
CAUSE
The "hour- The HAND Wait for a few minutes for the Remington iLIGHT
glass" icon PIECE on the device to cool down. There is no need to shut
is flashing Remington the unit down. The hourglass icon illuminates
yellow iLIGHT device and the device beeps until the device is ready to
and the needs some use again.
Remington time to cool
iLIGHT down.
device is
The room is Use the Remington iLIGHT device in a cooler
beeping.
too warm for environment, where the temperature is less
the Remington than 80° F or 27° C.
iLIGHT device
to cool down.
43