Festo Soft Stop SPC11 Manual De Referencia Rápida página 18

S
The dimensions correspond to the standard sizes of
service units, proportional directional control valves
and drives.
S
If angled connectors cannot be avoided, use plug con-
nectors from the Quick Star series.
S
Do not use any restrictors in the supply lines.
Drive and measuring system
S
Use only the permitted combinations of valves, drives
and measuring systems approved of by Festo for the
SPC11.
S
Observe the permitted fitting positions.
S
Mount the measuring system symmetrical to the drive
stroke.
S
Mount the drive, the guide and the measuring system
free of play and flush in the direction of movement.
Specially for drives type DGP(I)(L)-...-...-KF or DGP-... with
suitable guide):
S
With bilateral air supply, open up completely the ad-
justing screws for the internal end position cushioning
(PPV).
S
Use a measuring system with the same stroke length.
18 Festo SPC11-... 0012NH English