Accessories; Installation Procedure; Before Installation - Kenwood KDC-X994 Guia De Inicio Rapido

Accessories

1
2
3
4
5
(KDC-X994 / KDC-BT945Uonly)

Installation Procedure

1. To prevent a short circuit, remove the key
from the ignition and disconnect the -
battery.
2. Make the proper input and output wire
connections for each unit.
3. Connect the speaker wires of the wiring
harness.
4. Connect the wiring harness wires in the
following order: ground, battery, ignition.
5. Connect the wiring harness connector to
the unit.
6. Install the unit in your car.
7. Reconnect the - battery.
8. Press the reset button.
10 | Quick Start Guide

Before Installation

2WARNING
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
.....1
(ground), you may cause a short circuit,
that in turn may start a fire. Always connect
those wires to the power source running
through the fuse box.
¤
.....2
• Mounting and wiring this product
.....4 • Make sure to ground the unit to a
• Do not install the unit in a spot exposed
.....4
• Do not use your own screws. Use only
• If the power is not turned ON ("PROTECT"
.....1 (9.5 ft)
• If your car's ignition does not have an ACC
• If the console has a lid, make sure to
• If the fuse blows, first make sure the wires
• Insulate unconnected wires with vinyl
requires skills and experience. For safety's
sake, leave the mounting and wiring work
to professionals.
negative 12V DC power supply.
to direct sunlight or excessive heat or
humidity. Also avoid places with too
much dust or the possibility of water
splashing.
the screws provided. If you use the wrong
screws, you could damage the unit.
is displayed), the speaker wire may have
a short-circuit or touched the chassis of
the vehicle and the protection function
may have been activated. Therefore, the
speaker wire should be checked.
position, connect the ignition wires to a
power source that can be turned on and
off with the ignition key. If you connect
the ignition wire to a power source with
a constant voltage supply, as with battery
wires, the battery may die.
install the unit so that the faceplate will
not hit the lid when closing and opening.
aren't touching to cause a short circuit,
then replace the old fuse with one with
the same rating.