Yamaha YSP-1400 Manual De Instrucciones página 16

5
Make the unit learn the volume (+) operation.
5-1 Press VOLUME (+) on the front panel of the unit.
5-2 While pointing your TV remote control at the remote control sensor, hold
down the volume (+) key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 5-1.
6
Make the unit learn the power operation.
6-1 Press (power) on the front panel of the unit.
6-2 While pointing your TV remote control at the remote control sensor, hold
down the power key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 6-1.
7
To finish the learning mode, press the LEARN or
the supplied remote control.
This completes the necessary settings. Now you can operate the unit with the TV
remote control's power key or volume keys.
HINT
• The learning mode will be finished automatically if no operations are performed for 5 minutes.
• Set the TV volume to minimum. When you turn up the volume of the unit with the TV remote control,
the volume of the TV may be turned up at the same time. In this case, follow Step 3 in "Connections"
(p.6) to change the TV setting.
14
Indicators
Lights up
Flash
Indicators
Lights up
Flash
(power) key on
Clearing all learned operations
1
With the unit turned off, hold down the LEARN key on the supplied
remote control for more than 3 seconds. (for entering the learning
mode)
When the unit is in the learning mode, the indicators on the front panel flash as
shown below.
2
Hold down INPUT on the front panel of the unit for more than 3
seconds.
If the clearing is completed, you will hear the bleep sound three times.
3
Press the LEARN or (power) key on the supplied remote control.
Flashes in red (cleared)