Aprimatic BA 230 Instrucciones Para La Instalación Electrica, El Uso Y El Mantenimiento página 20

Wings operation
Before starting the learning manoeuvre it might be necessary to adjust the position of the wings:
Press buttons P1 and P2 at the same time until the PROG LED will turn on
Release buttons.
Press and hold button P1 for wing 1 closing movement, release and press again
for wing 1 opening movement and so on.
Press and hold button P2 for wing 2 closing movement, release and press again
for wing 2 opening movement and so on.
At the end press P1 and P2 at the same time until the PROG LED will turn off
2.1 Double wing saving procedure without wings lag
Reduced procedures allow saving only slowing down spaces, while wings lags are set to 2 seconds during opening and 4
seconds during closing
2.1.1 DOUBLE WING WITH SLOW-DOWN STROKE
Fully close the gate.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing: release button P1.
Press SEQ: Wing 1 will start opening.
When you decide to start the slowing down stroke phase press SEQ: wing 1 will slow down.
When wing 1 is completely opened press SEQ: wing 2 will start opening.
When you decide to start the slowing down stroke phase press SEQ: wing 2 will slow down.
When wing 2 is completely opened press SEQ: wing 2 will start closing.
When you decide to start the slowing down stroke phase press SEQ: wing 2 will slow down.
When wing 2 is fully closed press SEQ: wing 1 will start closing.
When you decide to start the slowing down stroke phase press SEQ: wing 1 will slow down.
When wing 1 is fully closed press SEQ
Wait for the PROG LED to turn off: saving completed.
2.1.2 DOUBLE WING WITHOUT SLOW-DOWN STROKE
Set the trimmer TR3 SLOW. SPEED to the maximum.
Fully close the gate.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing: release button P1
Press SEQ: Wing 1 will start opening.
When wing 1 is completely opened press SEQ: wing 2 will start opening.
When wing 2 is completely opened press SEQ: wing 2 will start closing.
When wing 2 is fully closed press SEQ: wing 1 will start closing.
When wing 1 is fully closed press SEQ
Wait for the PROG LED to turn off: saving completed.
2.2 Double wing saving procedure with wings lag
Complete procedures allow also saving wing lags
2.2.1 DOUBLE WING WITH SLOW-DOWN STROKE
Fully close the gate.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing
Do not release P1 button and hold it pressed for further 3 seconds
PROG LED starts flashing at an increased frequency: release P1
Press SEQ: Wing 1 will start opening.
When you decide to start the slowing down stroke phase press SEQ: wing 1 will slow down.
When wing 1 is completely opened press SEQ: wing 2 will start opening.
When you decide to start the slowing down stroke phase press SEQ: wing 2 will slow down.
When wing 2 is completely opened press SEQ: wing 2 will start closing.
When you decide to start the slowing down stroke phase press SEQ: wing 2 will slow down.
When wing 2 is fully closed press SEQ: wing 1 will start closing.
When you decide to start the slowing down stroke phase press SEQ: wing 1 will slow down.
BA230
20