Aprimatic BA 230 Instrucciones Para La Instalación Electrica, El Uso Y El Mantenimiento página 21

When wing 1 is fully closed press SEQ
Press SEQ: wing 1 starts opening movement and as soon as the wing lag time is decided press SEQ again: wing 2
will move.
Wait for the complete opening of wing 2
Press SEQ: wing 2 starts closing movement and as soon as the wing lag time is decided press SEQ again: wing 1
will move.
Wait for the complete closing of wing 1.
Wait for the PROG LED to turn off: saving completed.
2.2.2 DOUBLE WING WITHOUT SLOW-DOWN STROKE
Set the trimmer TR3 SLOW. SPEED to the maximum.
Fully close the gate.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing
Do not release P1 button and hold it pressed for further 3 seconds
PROG LED starts flashing at an increased frequency: release P1
Press SEQ: Wing 1 will start opening.
When wing 1 is completely opened press SEQ: wing 2 will start opening.
When wing 2 is completely opened press SEQ: wing 2 will start closing.
When wing 2 is fully closed press SEQ: wing 1 will start closing.
When wing 1 is fully closed press SEQ
Press SEQ: wing 1 starts opening movement and as soon as the wing lag time is decided press SEQ again: wing 2
will move.
Wait for the complete opening of wing 2
Press SEQ: wing 2 starts closing movement and as soon as the wing lag time is decided press SEQ again: wing 1
will move.
Wait for the complete closing of wing 1.
Wait for the PROG LED to turn off: saving completed.
2.3 Single wing saving procedure
Single wing procedures allow to configure the single wing gate
2.3.1 SINGLE WING WITH SLOW-DOWN STROKE
Fully close the gate.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing
Do not release P1 button and hold it pressed for further 3 seconds
PROG LED starts flashing at an increased frequency
Do not release P1 button and hold it pressed for further 3 seconds
PROG LED starts flashing at an increased frequency: release P1
Press SEQ: Wing 1 will start opening
When you decide to start the slowing down stroke phase press SEQ: wing 1 will slow down.
When wing 1 is completely opened press SEQ: wing 1 will start closing
When you decide to start the slowing down stroke phase press SEQ: wing 1 will slow down.
When the wing is fully closed press SEQ
Wait for the PROG LED to turn off: memorization completed.
2.3.2 SINGLE WING WITHOUT SLOW-DOWN STROKE
Set the trimmer TR3 SLOW. SPEED to the maximum.
Fully close the gate.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing
Do not release P1 button and hold it pressed for further 3 seconds
PROG LED starts flashing at an increased frequency
Do not release P1 button and hold it pressed for further 3 seconds
PROG LED starts flashing at an increased frequency: release P1
Press SEQ: Wing 1 will start opening
When wing 1 is completely opened press SEQ: wing 1 will start closing
When the wing is fully closed press SEQ
Wait for the PROG LED to turn off: saving completed.
BA230
21