Release Of The Automation; Electrical Connections - Erreka AZIMUT AZS50E Manual Del Usuario

RELEASE OF THE AUTOMATION

In order to release the automation from inside, pull the knob
downwards.
CAUTION: Do not use the knob to open the door.
It is prohibited to hand objects off the release cord.
In order to release the automation from outside, install the
accessory release kit (code APL02).
WARNING: If the door is unlocked to be opened, when
it will be closed it is automatically locked for security
reasons.
If the power supply is not available, the door can be opened
only by acting again on the release knob.
If there are no secondary accesses to the garage we
recommend the installation of the device to unlock from the
outside (code APL02)

ELECTRICAL CONNECTIONS

The control panel inside AZIMUT is already cabled.
You just need to plug it in the electrical outlet to proceed with
operational parameter programming.
To connect the photocells and the START button, please refer to
the following diagram:
30