Error: Reset; Overvoltage Problem - Megger Ducter DLRO-10 Guia Del Usuario

Battery Module and Care
Flashing
Flashin

Error: Reset

An error has occurred within the
battery module. The circuitry is
resetting. Wait a few moments and
the fault should clear.

Overvoltage problem

The charging supply voltage is
too high. Disconnect the charger
and rectify the fault. If the battery
module is not disconnected
damage could occur. This is
most likely to happen if charging
from a d.c. supply where the
supply is 24 V instead of the
necessary 12 V.
17