Teka HLB Guía De Uso página 45

Pyrolytic self-cleaning function
WARNING
Before carrying out the pyrolytic cleaning
cycle, carefully read the safety instructions
found at the beginning of the Installation and
Maintenance booklet.
This feature allows you to run the pyrolytic
cleaning cycle during which built-up grease
deposits are burned off by the high temperatures
inside the oven.
Generally, a pyrolytic cycle is recommended
after every 4-5 uses; choose the most suitable
programme depending on how dirty your oven
is. For very dirty ovens, choose a longer cycle.
During the pyrolytic cycle the light inside the
oven will remain off.
PROGRAMMING THE
PYROLYTIC FUNCTION
IMPORTANT
Before carrying out the pyrolytic cleaning
cycle, remove all accessories and dishes from
the oven, including the shelf runners and/or
telescopic guide rails. To clean these follow
the instructions in the Installation and Mainte-
nance booklet that comes with your oven.
WARNING
Clean any spillages or excess dirt, as during
the pyrolytic cleaning cycle these can ignite
and become a fire hazard.
WARNING
Before running the pyrolytic cycle, ensure
that the oven is properly closed.
1. Turn the oven on and select the Pyrolysis
feature using the left dial.
2. Use the right dial to choose the most
suitable pyrolytic programme depending on
how dirty your oven is:
P1: Gentle pyrolysis. Lasts 1 hour.
P2: Medium pyrolysis. Lasts 1.5 hours.
P3: Intensive pyrolysis. Lasts 2 hours.
3. Confirm your choice with the
Immediately afterwards, the door will lock
automatically.
WARNING
If the door is not properly closed, the
pyrolysis cycle will not begin. An audible
signal will sound and the symbol will flash on
the screen .
If this occurs, close the door properly to
activate the lock and start the pyrolytic cycle.
4. When the door is locked the
light up on the clock display and the time
remaining until the end of the cycle will be
shown.
English
button.
symbol will
45
User's Guide