Quick User Guide - Victron energy Blue Power IP22 12/15 Manual De Instrucciones

1. Quick user guide

A. Connect the charger to the battery or batteries (see figure 1).
B. Connect the charger to the wall socket. The BULK LED will
indicate that the mains cable is connected to the wall socket.
C. If required, press the MODE-button to select another charging
algorithm (the charger remembers the mode when disconnected
from the mains and/or the battery).
If reconditioning is selected, the RECONDITION LED will be on,
and will flash when reconditioning is active.
The charger switches to NIGHT by pressing the MODE button
during 3 seconds. The NIGHT LED will turn on. The NIGHT mode
automatically ends after 8 hours, and can be ended earlier by
again pressing the MODE button during 3 seconds.
The charger switches to LOW by pressing the MODE button
during 6 seconds. The NIGHT LED will blink twice per second.
The LOW mode remains activated until the MODE button is
pressed again during 6 seconds.
When NIGHT or LOW are on, the output current is reduced to
max. 50% of the nominal output and the charger will be totally
noiseless.
D. The battery is about 80% charged and ready for use when the
absorption LED switches on.
E. The battery is fully charged when the FLOAT or STORAGE
LED is on.
F. Stop charging at any time by interrupting the AC supply.
1