HoMedics enviraScape MIDNIGHT VALLEY Manual De Instrucciones E Información De Garantía página 3

C
D
Package Contents
Part Description
A
Trees
Rock (Top)
B
C
Water Tube (attached to B)
Water Pump (attached to F)
D
Light Bulb (attached to D)
E
F Fountain Base
G Power Cord
H On/Off Switch (attached to G)
I Adapter
A
B
I
E
F
H
G
Quantity
1
1
1
1
1
1
1
1
1
4
Assembly and Instructions for Use
Unpack the product. Be sure that all parts listed are included. Familiarize yourself
with the WATER PUMP (D) before completing assembly of fountain. It is
recommended the WATER PUMP be set at its highest speed during assembly and
later adjusted to a lower setting if desired.Be sure to unplug the WATER PUMP
before adjusting the speed setting.The WATER PUMP speed is controlled by the
switch located at the front of the WATER PUMP (Figure 1). The speed is indicated
by a plus (+) and minus (-) sign. To increase the speed, move the switch slowly in
the direction of the plus sign. At its highest speed level, the switch will not move any
further. To decrease the WATER PUMP speed, move the switch toward the minus
sign. Similarly, at its lowest speed, the switch will not move any further. Once you
are familiar with the WATER PUMP , begin assembly.
Figure 1
Attention:
In order to get best
results, please
operate pump
completely
submerged.
Keep the water
level above the
minimum water
level ALL THE TIME.
1. Insert the black connector at the bottom of the WATER TUBE (C) into the round
opening of the WATER PUMP (D). (Figure 2)
2. Insert waterproof LIGHT BULB (E) into hole in center of the ROCK top (B) (Figure 3).
Dampening and slightly twisting the LIGHT BULB may help it to more easily pass
through the rubber hole. Be gentle with the bulb since it is made of glass.
W W a a r r n n i i n n g g : : B B u u l l b b g g e e t t s s v v e e r r y y h h o o t t . . A A l l l l o o w w t t o o c c o o o o l l c c o o m m p p l l e e t t e e l l y y b b e e f f o o r r e e t t o o u u c c h h i i n n g g . .
Figure 2
C
D
Minimum Water Level
Flow Control Lever
(+) faster water output
(-) slower water output
Figure 3
5