Installation - Everbilt SUP80-HD Guía De Uso Y Cuidado

Installation

IMPORTANT: Carefully thread all connections into the pump body to avoid stripping or crossing threads.
1. Install the pump on a firm, level base. Ensure the pump will not draw in rocks, debris, mud, etc. If necessary,
place a cement block under the pump to raise it slightly. If used with a fountain jet, position the pump so that
the fountain jet is above the surface of the water.
2. Make sure the power cord is protected from damage. Uncovered cords should be checked for wear or any
damage before each use. NEVER start a pump with a damaged cord.
3. Select the appropriate adapter and attach it to the pump.
4. If used in a garden pond, adjust the diverter valve to control the fountain spray height and flow over the
waterfall. Do not restrict pump suction to adjust flows. Restricting the suction will starve the pump for water and
can damage the pump.
5. If the pump is connected to a pond filter, adjust the diverter valve to provide adequate flow to the filter. Refer to
the filter instruction manual to determine flow requirement of the filter.
6. Lower pump into water before powering on. The pump has an air relief valve built-in to prevent air-lock. Air lock
can also be quickly broken by tilting the pump to horizontal then back to upright to allow air to escape. It can take
several seconds to break air lock if relying solely on air relief valve, this is normal.
NOTE: The fountain accessories are not included with this pump.
Typical Garden Pond and Waterfall Installation
6