Filters And Accessories; Water Filtration System - Whirlpool WRF954CIHZ00 Manual De Uso Y Cuidado

3. Move the refrigerator to its final location.
4. Using the 1/4" hex driver, lower the brake feet. Turn them
clockwise until the rollers are off the floor and both brake feet
are snug against the floor. This keeps the refrigerator from
rolling forward when opening the refrigerator doors or freezer
drawer.
IMPORTANT: If you need to make further adjustments
involving the brake feet, you must turn both brake feet the
same amount to keep the refrigerator level.
5. Use a level to make sure the refrigerator is level from side to
side and front to back.
6. Make sure the doors are even at the top and that the space
between the bottom of the refrigerator doors and the top of
the freezer drawer is even. If necessary, align the doors.
To Align the Doors:
Keeping both refrigerator doors closed, pull out the freezer
■
drawer. Locate the bottom hinge pin of the right-hand
refrigerator door. The alignment screw is inside the bottom
hinge pin.
Insert the short end of the 1/8" hex key (packed with the Door
■
Handle Installation Instructions) into the bottom hinge pin
until it is fully engaged in the alignment screw.
To raise the refrigerator door, turn the hex key to the right.
To lower the door, turn the hex key to the left.
Continue to turn the alignment screw until the doors are
■
aligned.
A. Bottom hinge pin
B. 1/8" hex key
7. Make sure the refrigerator is steady. If the refrigerator seems
unsteady or rolls forward when a door or drawer is pulled
open, adjust the brake feet.
To Steady the Refrigerator:
Open the freezer drawer. Using a 1/4" hex driver, turn
■
both brake feet clockwise the same amount until the
brake feet are snug against the floor. Check again. If you
are not satisfied, continue to adjust the brake feet by
half turns of the screw until the refrigerator does not roll
forward when the drawer is opened.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the brake feet. This makes
it easier to turn the screws. Do not push with excessive force
that tilts the refrigerator.
8. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place. Use a 1/4" hex driver to reinstall screws.
18
A
B
FILTERS AND
ACCESSORIES

Water Filtration System

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Replace and Install the Water Filter
The water filter should be replaced every 6 months based on a
flow rate of .50 gpm-.60 gpm (1.89 - 2.27 lpm) that filters 200
gallons (751.1L) of water.
To order a replacement filter, contact us. See the "Accessories"
section in the Use & Care Guide for information on ordering.
1. Push the water filter door to open, located bottom left of
refrigerator compartment.
2. Twist the water filter and turn 90° counterclockwise to unlock.