Using The Controls - Whirlpool WRF954CIHZ00 Manual De Uso Y Cuidado

Refrigerador de dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The touch-activated controls are located above the external
dispenser and on the side of the left inner refrigerator door.
NOTE: Some models do not have the 2nd Ice Off control.
Viewing and Adjusting Temperature Set Points
For your convenience, your refrigerator and freezer controls are
preset at the factory.
When you first install your refrigerator, make sure that the
controls are still set to the recommended set points. The factory-
recommended set points are 37°F (3°C) for the refrigerator and
0°F (-18°C) for the freezer.
IMPORTANT:
Wait 24 hours before you put food into the refrigerator. If you
add food before the refrigerator has cooled completely, your
food may spoil.
NOTE: Adjusting the set points to a colder-than-
recommended setting will not cool the compartments
any faster.
If the temperature is too warm or too cold in the refrigerator
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The recommended settings should be correct for normal
household use. The controls are set correctly when milk or
juice is as cold as you like and when ice cream is firm.
NOTE: Areas such as a garage, basement, or porch may have
higher humidity or extreme temperatures. You may need to
adjust the temperature away from the recommended settings
to accommodate for these conditions.
Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
22

Using the Controls

View Temperature Set Points
Touch [▼]/[▲] for refrigerator or [▼]/[▲] for freezer to toggle
through temperature set points.
NOTE: To view temperature in degrees Celsius, touch
and hold the [°F-°C] button for 3 seconds and the temperature
display will change. To return to Fahrenheit, touch and hold
[°F-°C] for 3 seconds and the temperature display will change.
To activate Temperature mode for Pantry Drawer, touch DRAWER
and toggle through 4 optional temperature settings: Meats,
Deli-Cheese, Assorted, and Drinks. The display will show the
temperature set point of the selected setting for the Pantry
Drawer.
Adjust Temperature Set Points
Refrigerator set point range: 33°F to 45°F (1°C to 7°C)
Freezer set point range: -6°F to 5°F (-22°C to -15°C)
1. Touch [▼]/[▲] to adjust the Refrigerator zone. The display will
show the temperature set point of the selected compartment
as shown.
2. When the temperature is in the range of Freeze Shield, the
display will light up. Freeze Shield is active at the coldest
freezer set point.
CONDITION:
REFRIGERATOR too cold
REFRIGERATOR too warm
FREEZER too cold
FREEZER too warm/
Too little ice
Recommended Refrigerator Temperature
Recommended Freezer Temperature
When adjusting temperature set points,
use the following chart as a guide:
TEMPERATURE ADJUSTMENT:
REFRIGERATOR setting 1° higher
REFRIGERATOR setting 1° lower
FREEZER setting 1° higher
FREEZER setting 1° lower

Publicidad

Tabla de contenido
loading

Tabla de contenido