Cord Storage; Operation - RIDGID WD0625 El Manual Del Propietario

Vac Assembly (continued)
Insert the flexible plastic end of the hose,
which is opposite the swivel end, into the
vacuum port.
Place the utility nozzle securely on the
swivel end of the hose and the vac is
ready for use.
NOTE: The swivel end of the hose is
removable if more hoses need to be
attached for more length from the vac. To
remove the swivel portion of the hose,
grasp the hose swivel and firmly pull it out
of the flexible hose. Connect the soft end
of a second hose (accessory #VT-2507)
into the swivel end of the original hose by
forcing the sections together until they fit
tightly. You can also connect two hoses
together by purchasing VT2511 (Hose to
Hose connector).

Operation

To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to; lighter fluid, solvent type cleaners, oil-
base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but
are not limited to; coal, magnesium, grain or gun powder. Do not vacuum
explosive dust, flammable or combustible liquids or hot ashes. Do not use
this vac as a sprayer. To reduce the risk of health hazards from vapors or
dusts, do not vacuum toxic materials.
CAUTION: To reduce risk of hearing
damage wear ear protectors when
using the vac for extended hours or
when using it in a noisy area. The
operation of any utility vac can result
in foreign objects being blown into
the eyes, which can result in severe
eye damage. Always wear safety
goggles complying with ANSI Z87.1
(or in Canada CSA Z94.3-99) shown
on Package before commencing
operation. Safety Goggles are avail-
able at many local retail stores.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug

Cord Storage

Simply, wrap the power cord around the
powerhead (as shown) and snap the con-
nector on the plug to a wrap of the cord.
Cord Wrap
Area
Dust
Drum
WARNING
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a quali-
fied electrician to install the proper outlet.
Do not change the plug in any way.
After you plug the power cord into the out-
let, turn the unit on by pushing the switch
from position "O" to position "l". The sym-
bols used on the motor cover are interna-
tional "On & Off" symbols. "O" is the
symbol for "OFF" and "l" is the symbol for
"ON".
Familiarize yourself with the accessories
included with the vac. Each accessory
may be used in various ways for vacuum-
ing and blowing debris. Here is a list of the
accessories and their uses.
6
On-Off Switch
Caster Feet
Casters
w/Accessory
Storage
= OFF
Power Cord
Handle
Hose
Utility
Nozzle
= ON