Cleaning Agitator; Replacing Brushes - Panasonic MC-V5210 Instrucciones De Operación

Ocultar thumbs Ver también para MC-V5210:
Tabla de contenido

Publicidad

E-Clip
Bride en E
Sujetador de E
Agitator Shaft
Arbre d'entraînement
Eje del agitador
Agitator Pulley
Poulie de l'agitateur
Polea del agitador
Push Off
Pousser
Empuje hacia fuera

Cleaning Agitator

Replacing Brushes

Card
Carte
Tarjeta
Right End Cap
Bouchon droit
Tapa del extremo
derecho
Agitator Holder
Support de l'agitateur
Soporte del agitador
Brush
Brosse
Cepillo
Clean agitator after every five uses
and every time the belt is replaced.
Remove lower plate.
Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
Remove agitator.
Remove any string or debris located
on the end caps, washers or agitator
shaft.
Reinstall agitator and lower plate.
When the bristles on the agitator are
worn so that they do not touch a card
held across the lower plate, the
brushes should be replaced.
Remove lower plate and agitator.
Remove the E-clip from agitator shaft
and end cap.
Do not bend agitator shaft or lose E-
clip or spacer.
Pull agitator shaft out of agitator body.
Pull, or pry out, agitator holder and
agitator pulley.
Push each brush out of agitator body
as shown.
Install new brushes by reversing
procedure.
Reinstall agitator holder and agitator
pulley completely.
Reinstall the agitator shaft, end cap
and E-clip.
See exploded view for correct
assembly of parts.
Position belt over agitator pulley on
the agitator.
Reinstall agitator and lower plate.
- 32 -

Publicidad

Tabla de contenido
loading

Tabla de contenido