Cleaning Agitator - Panasonic MC-UG383 Instrucciones De Operación

Belt
Courroie
Correa
Motor Shaft
Arbre d'entraînment
du moteur
Eje del motor
+
Groove
Ouverture
Ranura
+
Replacing Belt
Agitator
Agitateur
Agitador
End Cap
Bouchon
Tapa del extremo

Cleaning Agitator

➢ ➢ Remove worn or broken belt.
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and belt
pulley; see illustration for correct belt
routing.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate.
➢ ➢ Clean agitator after every five uses
and every time the belt is replaced.
➢ ➢ Remove lower plate.
➢ ➢ Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
➢ ➢ Remove agitator.
➢ ➢ Remove any string or debris located
on the end caps.
➢ ➢ Reinstall agitator and lower plate.
- 30 -