Tare; Setting A Reference Weight; Check Weighing; Explanation - MS Schippers MS Animal ID Instrucciones Para El Uso

3.2 Tare

Reset the scale to zero by pressing the
Place a box or crate on the platform. This weight appears on the display.
Press the key to set the tare weight. The weight displayed is stored as the tare weight, which is
substracted from the display. The display shows 0 and the NET indicator appears. If a product is now
weighed, only that weight is displayed. A second tare weight can be set, for example if another type of
product is added. Again, only the weight of the added product is shown on the display.
If the box or crate is removed, a negative weight is displayed. If TARE is pressed just before removing
the box, the gross weight is displayed (= box + products). The ZERO indicator appears because the
scale is in the same state as when the

3.3 Setting a reference weight

To set a reference weight, tare the empty box first and then place the product in the box. The display
shows the weight and the number of products present.

4. Check Weighing

4.1 Explanation

In check weighing, an alarm or beep sounds when the weight on the scale reaches or exceeds the value
set in the memory. The memory stores an upper (high) and a lower (low) limit.
Check mode: OK
During check weighing, OK appears on the display and the beep sounds if the weight is within the two
limits.
Check mode: NG (not good)
During check weighing, NG appears on the display and the beep sounds if the weight is outside the
two limits.

4.2 Set Limits

Press and key together, display will show "set h".
Press key to select "set h" or "set l".
Press key to confirm, display will show 00000 and the last digit will blink.
Enter the high limit value by using
key to increment the value.
26
key if necessary. The ZERO indicator appears.
key was last pressed.
and keys to change the active digits and press