16. The calibration is ready when the display shows pass
12. Parameters
12.1 Parameters for MS EasyScale Pro Select 4309763
To set parameters, turn on the scale.
Press
key during the self-checking.
Display will show "pn".
Press
,
and
Menu
Sub Menu
P 0 chk
Set H
Set lo
beep
P1 ref
A 2n 0
0auto
0range
0tare
Speed
Zero
P 2 com
Mode
32
to enter, display will show "po chk".
Description
Set high limit for check weighing
Set low limit for check weighing
No
No beep for check weighing
Ok
Beep, when check weighing within limits
ng
Beep, when check weighing outside limits
Automatic zero tracking
Options: 0 , .5d ,1 d , 2 d , 4 d
Zero setting range, after resetting the scale to zero.
Options: 0 , 2 , 5 ,10 , 20 , 50 , 100
Manual zero setting range.
Options: 0 , 2 , 5 ,10 , 20 , 50 , 100
Auto zero tracking for NET mode.
(After pressing tare, NET weight will be zero)
Option: on / off
Set the ADC speed
Option: 7.5 / 15 / 3 0 / 60
Set new zero point
This option is used to set accumulation and RS-232
communication
Options:
Cont
: Continue data sending
St 1
: Send data once, when stable
St c
: Send data continuously, when stable
Pr 1
: Send data once, when print Key is pressed
(in printer mode)
Pr 2
: Send data to print and accumulation,