Parameters For Bws In Combination With Weighing Beams And As Weighing Platform - MS Schippers MS Animal ID Instrucciones Para El Uso

12.3 Parameters for BWS in combination with weighing beams and as weighing platform

To set parameters, turn on the scale.
Press key during the self-checking.
Display will show "pn".
Press , and
Menu Sub Menu
P 0 chk Set H
Set lo
beep
P1 ref A 2n 0
0auto
0range
0tare
Speed
Zero
P 2 com Mode
38
to enter, display will show "po chk".
Description
Set high limit for check weighing
Set low limit for check weighing
No No beep for check weighing
Ok Beep, when check weighing within limits
ng Beep, when check weighing outside limits
Automatic zero tracking
Options: 0 .5d ,1 d,, 2 d , 4 d
Zero setting range, after resetting the scale to zero.
Options: 0 , 2 , 5 ,10 , 20 , 50 , 100
Manual zero setting range.
Options: 0 , 2 , 5 ,10 , 20 , 50 , 100
Auto zero tracking for NET mode.
(After pressing tare, NET weight will be zero)
Option: on / off
Set the ADC speed
Option: 7.5 / 15 / 3 0 / 60
Set new zero point
This option is used to set accumulation and RS-232
communication
Options:
Cont : Continue data sending
St 1 : Send data once, when stable.
St c : Send data continuously, when stable
P r1 : Send data once, when print key is pressed
Pr 2 : Send data to print and accumulation,
Auto : Auto accumulate and auto print mode.
Ask : Ask mode,
Wireles : Wireless mode (wireless communication)
(in printer mode)
when key is pressed
When weight is stable, return to zero.
Command R: read data
Command T: Tare
Command Z: Zero