To Set The Static Correction Level - Petsafe Wireless Pet Containment System Guía Para El Uso

To Set the Static Correction Level

Note: Your Receiver Collar has been factory-set to Beep Only.
Read all steps before attempting to set the Static Correction Level.
1. Remove the clear plastic cover with a coin to expose the Correction
Level Button.
2. With the battery installed, press the Correction Level Button and
release when the Receiver LED Indicator Light lights up .
3. The Receiver LED Indicator Light will emit a series of fl ashes
representing the Static Correction Level.
4. Increase the Static Correction Level by pressing and releasing the
Correction Level Button within 5 seconds of the previous series of
fl ashes.
5. After setting the Static Correction Level, replace the cover to
protect the Correction Level Button.
The Static Correction levels increase in strength from 1 to 6. Pushing
the Correction Level Button while the Receiver Collar is on level 6 will
cause the Receiver Collar to revert to level 1. Refer to the Function and
Response Table to choose the Static Correction level that best fi ts your pet.
4 1-800-732-2677