Craftsman 126.32564 Manual Del Operador página 23

45 o Bevel Stop Adjustment
1. Loosen the Bevel Lock Handle and tilt the
Cutting Head completely to the left until it
rests against the 45 o stop.
2. Use a combination square to see if the
blade is at 45 oto the table.
3. If the saw blade is not in exact alignment
adjustment is necessary.
4. Return the Cutting Head to its upright position.
5. Loosen the locknut on the 450 Bevel
Adjustment Screw.
6. Use an Allen Key to adjust the Adjustment
Screw in or out as required. (Fig. M)
1_, WARNING I
When all angular adjustments have been
successfully completed, the operation of
the lower safety guard must be checked
to ensure that it is working correctly.
The saw must not be used if the lower
safety guard is not operating correctly.
Fence Adjustment (Fig. N)
The fence must be aligned at 90o (square) to a
correctly installed blade.
The rotary table must be set at '0°' miter angle.
The Fence is fastened to the table with two
socket head Allen screws positioned at either
side of the fence in elongated slots.
1. Place a combination square on the table
with the rule against the Fence and the heel
against the Blade. (CuttingHead removed for
illustrative purposes only in Fig N below)
(Fig. M)
7. Tilt the Cutting Head to the 45o setting and
recheck for alignment with the combination
square.
8. Repeat steps 1 to 7 until the correct
angular alignment is achieved.
9. Tighten the Adjustment Screw Iocknut
securely once alignment is achieved.
(Fig. N)
2. If adjustment is necessary, loosen the two
Fence adjustment screws using an Allen Key.
3. Re-position the Fence in its elongated
slots until alignment is achieved.
4. Securely tighten the socket head screws.
23