Craftsman 126.32564 Manual Del Operador página 8

21. USE THIS COMPOUND MITER SAW
ONLY FOR Wood and wood based materials.
DO NOT use it to cut Stainless Steel,
Masonry or Asbestos-based materials.
22. NEVER cut small pieces.
If the workpiece being cut would cause your
hand or fingers to be within 6-3/8 inch of the
saw blade the workpiece is too small.
26. SHUT OFF the power before servicing or
adjusting the tool.
27. DISCONNECT the saw from the power
source and clean the machine when cutting
is finished.
28. MAKE SURE the work area is clean
before you leave the machine.
23. PROVIDE adequate support to the sides
of the saw table for long workpieces.
24. NEVER use the miter saw in an area with
flammable liquids or gases.
25. NEVER use solvents to clean plastic
parts. Solvents could possibly dissolve or
otherwise damage the material.
29. SHOULD any part of your miter saw be
missing, damaged, or fail in any way, or any
electrical component fail to perform properly,
lock the switch and remove the plug from the
power supply outlet.
Replace missing, damaged, or failed parts
before resuming operation.
8