Bevel Cut - Craftsman 126.32564 Manual Del Operador

MAKING A BEVEL CUT (Fig. U) MAKING A COMPOUND CUT (Fig. V)
The Cutting Head can be set at any angle up
to a 45 oto the Left Hand side only.
The Bevel Angle Lock Handle is found at the
rear of the machine.
A compound cut is a combination of a
miter and bevel cut.
Select the required miter angle as
previously described in MAKING A
MITER CUT.
Select the required bevel angle as
previously described in MAKING A
BEVEL CUT
Ensure the tightness of all adjustment/
locking screws before making a cut.
(Fig. U)
Loosen the Bevel Lock Handle
Tilt the Cutting Head to the desired
angle. A protractor guide is provided
behind the Bevel Lock Handle to aid
setting.
Ensure the handle is tightened securely
when the required angle has been
achieved.
(Fig. V)
Proceed to make the cut as previously
described in MAKING A BASIC CUT.
31