Product Specifications; Double Insulated - Craftsman 126.32564 Manual Del Operador

WARNING l
POWER SUPPLY AND MOTOR
SPECIFICATIONS
The AC motor used in this saw is a universal,
non-reversible type. See "MOTOR" in the
"PRODUCT SPECIFICATIONS"
section on page 3.
To reduce the risk of electrical shock, this
saw has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse plug. If it still does
not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in
any way.
,A WARNING l
To avoid electrical hazards, fire hazards,
or damage to the tool, use proper circuit
protection. Your saw is wired at the factory
for 120V operation. Plug the saw into a 120V,
15A electrical outlet. To avoid shock or fire, if
power cord is worn or cut, or damaged in any
way, have it replaced immediately.
DOUBLE INSULATED
This power toot is double insulated to provide
a double thickness of insulation between you
and the tool's electrical system. All exposed
metal parts are isolated from the internal
metal motor components with protecting
insulation.
Replacement parts - When servicing, use
only identical replacement parts.
Polarized plugs - This saw has a plug that
looks like the one shown below:
1_. WARNING I
Double insulation does not take the place of
normal safety precautions when
operating this toot.
To avoid electrocution:
1. Use only identical replacement parts
when servicing a tool with double insulation.
Servicing should be performed by
a qualified technician.
2. Do not use power tools in wet or damp
locations or expose them to rain or snow.
MOTOR SAFETY PROTECTION
IMPORTANT:
To avoid motor damage, the motor should be
blown out or vacuumed frequently to keep
dust from interfering with motor ventilation.
1. Plug the saw into a 120V, 15A electrical
outlet.
NOTE: When using an extension cord on a
circuit with a # 18 wire, the extension cord
must not exceed 25 feet in length.
2. If the motor will not start, release the
trigger switch immediately.
UNPLUG THE SAW. Check the saw blade
to make sure it turns freely.
9