WelchAllyn ProXenon 350 Instrucciones De Uso Y Manual De Servicio página 21

Directions for Use
3. Position the target approximately 16 inches away from
Luminaire.
4. Adjust Luminaire iris to project the largest spot onto the
target.
5. Confirm that your monitor correctly displays the video image.
If there is no video signal, refer to
on page 19.
6. While maintaining a stable image of the white target, press
and hold the Manual White Balance button (Push AWB),
located on the back of the Video Processor, for 5 seconds.
7 . Release the Manual White Balance button. White Balance is
now reset.
Chapter 2 Assembly and Operation
"Basic Troubleshooting"
17