Draining Tanks; Machine Maintenance - Tennant Q12 Manual Para El Operador Y Manual De Repuestos

DRAINING TANKS

DRAINING SOLUTION TANK
When finished with the job, suction out any unused solution from
the solution tank. Place the end of the vacuum hose that was
attached to the wand into the solution tank and turn the vacuum
switch on.
DRAINING RECOVERY TANK
1. Turn off all switches.
2. Drain the recovery tank by holding the end of the drain hose
with the cap above the machine. Remove the cap on the
drain hose. Lower the drain hose over a drain or a bucket
to drain the recovery tank.
NOTE: When using the Auto Dump feature, the recovery tank
must be rinsed and then drained with the drain hose after each
use.

MACHINE MAINTENANCE

To keep machine in good working condition, simply follow
machine maintenance procedures.
FOR SAFETY: When servicing machine,
unplug cords from wall outlets. Wear
appropriate personal protection
equipment as needed.
AFTER EACH USE
1. If chemicals are used in solution tank flush system with clean
water by running the machine using clean water at the end
of each job.
2. Drain and rinse out recovery tank.
Tennant Q12 (01/2014)
3. Remove the Ball Float Screen, unscrew the Solution Tank Inlet
Filter and Recovery Tank Filter. Remove the debris from the
screen and filters. Be sure to replace the Ball Float Screen,
Solution Tank Inlet Filter and Recovery Tank Filter securely.
4. Wipe down the machine with a damp cloth. Do not hose off
or power spray machine.
5. Inspect solution hose and vacuum hose for cracks or damage
Do not use hose if damaged.
6. Store machine with tank covers off to promote air circulation.
7. Inspect the electrical cord ends on the machine and the
power cords used with the machine for damage. Replace
power cords if damaged and contact service center or a
qualified service person if electrical cord ends on machine
are damaged.
8. Coil power cords neatly after each use and store on
machine.
AFTER 80 HOURS OF USE
Flush solution lines and pump with a descaling solution (such as
white vinegar) to remove mineral accumulation which may have
formed from the use of hard water. Remove spray tips from hard
surface tool and soak in a descaling solution. Re-attach tool and
hose to machine. Pour solution into solution tank and run solution
through system by turning on pump and activating tool. Do not
recycle solution as it will carry small mineral deposits. After running
solution through system flush with clean water and reinstall spray
tips.
EN
English
Ball Float
Screen
Recovery
Tank Filter
Solution
Tank Filter
9