Dmx Linking - Chauvet DJ COLORband PIX Guía De Referencia Rápida

COLORband PiX USB QRG

DMX Linking

Starting
Address
Master/Slave
Connection
Infrared
Remote
Control
D-Fi USB
Connectivity
The COLORband PiX USB can work with a DMX controller when linked by DMX
serial connections. Instructions for DMX operation are in the User Manual. A DMX
Primer is available from www.chauvetlighting.com.
To ensure full access to all channels in each DMX mode, the highest recommended
DMX address is 472.
The COLORband PiX USB uses the DMX data connection for its Master/Slave mode.
Instructions for connecting and configuring this product for Master/Slave operation are in
the User Manual.
·
A COLORband PiX USB must be the master product when in Master/Slave
configuration with COLORband PiX products.
·
Slave products must be set to 36CH mode.
The COLORband PiX USB is fully compatible with the Infrared Remote Control
(IRC-6) from CHAUVET DJ For more information on the IRC-6 or to download
instructions, go to www.chauvetlighting.com.
The COLORband PiX USB is able to become a D-Fi wireless receiver/transmitter with
the use of the D-Fi USB from CHAUVET DJ. Simply set the DIP switch D-Fi
receiving/transmitting channel, plug it into the USB port then set the product's DMX
Personality and DMX Address. Further instructions for connecting and configuring this
product for D-Fi USB operation are in the User Manual.
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port.
Doing so may cause damage to the product.
Once plugged in, the D-Fi USB will take over the product. Wired DMX, manual
display control/menu buttons and IRC-6 will be unavailable until you unplug the
D-Fi USB. The priority levels are:
1. D-Fi USB
2. Wired DMX
3. IRC-6 Remote Control
4. Manual Digital Display/Menu Buttons
5
EN