MZ electronic FF-300 Instrucciones De Uso página 24

Installing the FF-300
(see electrical diagram)
Attention
ALWAYS
STARTING THE INSTALLATION.
The instrument must be positioned so that the display can be easily read and is not
exposed to sun rays.
The back part of the instrument must be protected from contact with water or humidity.
The instrument can be fastened on dashboards with any thickness. The fastening screws
must be self-threading with a diameter of 3.5 mm (~9/64") and a maximum length of 10
mm plus the thickness of the dashboard.
In the back part, on the dashboard, there must be a minimum space of 35 mm (~1"3/8).
Furthermore, there must be access for installation and maintenance.
following the drawing of the fastening holes, make a hole with a diameter of 30 mm (~ 1"
3/16) as indicated and 4 holes with a diameter of 4 mm (~5/32") for the
fastening screws of the volumeter -amperometer. Cut
the three pegs on the back side of the instrument with
cutting nippers, place the fuel consumption display and
fasten it to the dashboard by tightening the two screws.
If there already is a 54-mm hole (2"1/8), the back
pegs do not need to be cut.
FF-300
DISCONNECT THE BATTERY
- 24 -
English
BEFORE
Rev. 05-2011